distribution of velocities中文是什么意思

• 速度分布

• "distribution"中文翻译    n. 1.分配，分发，配给；分配装置[系统]；配给品；配 ...
• "velocity"中文翻译    n. 1.迅速；快速。 2.速度，速率。 3.周转率。 ...
• "distribution of velocities of flow" 中文翻译 :    临分布
• "ellipsiodal distribution of velocities" 中文翻译 :    速度的椭球形分布
• "ellipsoidal distribution of velocities" 中文翻译 :    速度椭球分布
• "law of distribution of velocities" 中文翻译 :    速度分布律
• "velocities" 中文翻译 :    速度
• "composition of velocities" 中文翻译 :    速度的合成; 速度合成
• "diagram of velocities" 中文翻译 :    速度图
• "discontinuity of velocities" 中文翻译 :    速度不连续性
• "dispersion of velocities" 中文翻译 :    速度弥散度
• "generalized velocities" 中文翻译 :    广义速度
• "of velocities law" 中文翻译 :    速度定律
• "parallelogram of velocities" 中文翻译 :    生代; 速度的平行四边形; 速度平行四边形
• "polygon of velocities" 中文翻译 :    速度多边形
• "resultant of velocities" 中文翻译 :    速度的合成
• "triangle of velocities" 中文翻译 :    速度三角形
• "body wave velocities" 中文翻译 :    体波速度
• "correlation-radial-velocities" 中文翻译 :    交叉相关视向速度仪
• "i tantaneous center of velocities" 中文翻译 :    瞬时速度中心
• "instantaneous center of velocities" 中文翻译 :    瞬时速度中心
• "instantaneous interval velocities" 中文翻译 :    瞬时层速度
• "seismic stacking velocities" 中文翻译 :    地震叠加速度
• "distribution" 中文翻译 :    n. 1.分配，分发，配给；分配装置[系统]；配给品；配给量；【经济学】配给方法，配给过程；分红；【法律】(无遗嘱死亡者的)财产分配。 2.分布，配置，分布状态；【生物学】(生物的)分布范围；【无线电】频率分布。 3.分类，整理，区分。 4.【电学】配电；【机械工程】配汽；【印刷】拆版；【逻辑学】周延(性)。 5.销售。 the distribution of wealth 财富的分配。 the accurate distribution of zoological specimens 动物品种的精确分类。 live on charitable distributions alone 完全依靠配给救济品生活。 the distribution of coniferous forests 针叶林的分布范围。 the distribution of troops 部队配置。 The distribution of our school paper is now 3000. 我们校刊的发行量现在是3000份。 We have a good harvest but our distribution is bad. 我们丰收了，但是产品卖不出去。
• "of distribution" 中文翻译 :    分派价值; 分销途径；分销渠道; 销售渠道

• On the design case , the distribution of velocity , temperature and pmv - ppd of workstation are well
  在设计工况，工作区温度、速度、 pmv值分布均匀。
• The predicted distributions of velocities are in good agreement with experiment values , from which right results can be concluded . the results give the flow status directly
  将计算结果与前面的实验结果相比，证明计算结果正确，并给出了直观的速度分布图。
• 2 . the distribution of velocity and concentration field are gained by numerically simulating the pulsed non - steady flow field of riverway equipped with navigation lock , after salt water is drained it into
  2 、对船闸河道的脉冲状非稳态流场进行数值模拟，得出将盐水排放入后河道的浓度场和速度场分布。
• Using the above method , the problem of 3 - d field of velocity and pressure in the pump can be solved . then get the map of distribution of velocity and pressure field and analyze them
  用上述方法求解无堵塞泵叶轮内部三维湍流速度场和压力场，给出了速度和压力云图，并对数值计算结果进行了分析和研究。
• To analyze the hydrodynamic structure of the estuary , 3d k - numerical model with curvilinear fitted coordinate has developed . the distribution of velocity and turbulent exchange coefficient at different time has obtained and analyzed
  紊流模型对测验河段进行计算，得到特征时刻该潮汐河口段的水力要素及垂向紊动混合系数的分布。
• The distributions of velocity vector , vorticity . turbulent kinetic energy and some other detailed flow information in the field are obtained . the influence of electric field on the flow field is discussed and gives a deep insight on it
  3 、首次采用piv技术对荷电喷雾射流流场进行了测量，获得了整个流场的瞬时速度、湍能、涡量等信息分布图，研究了流场特性随充电电压的变化情况。
• By the numerical simulation , calculate the distribution of velocity ^ temperature and contaminant concentration of air in the room under different modes of air flow organization , and through analysing the outcomes of simulation , draw some conclusions
  对常见的办公室环境，不同送回风方式下的室内空气的速度、温度及污染物浓度的分布进行模拟计算，并对模拟结果进行分析，得出结论。
• Then , we caculate the dynamic character of the reflective mtn cell with the optimized parameter , give out the distribution of velocity , twist angle and tilt angle at the midle of the mtn cell when switch on or off in consideration of the backflow
  并针对选定参数的mtn液晶盒作了动力学上的计算。文中分别了给出mtn盒在加电压和撤电压时，引流效应对反射率的影响，并比较指向矢，速度，中间层的倾斜角等参量分布的情况。
• Based on this theory , some experiments were done on two different hermetic cabins of two different man - made satellites . the results of the experiments give us the distribution of velocity . compare the results to the requested , and some suggestions can be given
  在该理论的指导下，分别对两个型号卫星密封舱的流动情况进行了实验研究，实验结果给出舱内的速度分布情况，并与要求的速度分布比较，由此对设计方案提出合理建议。
• Abstract : focused on the metal plastic forming of valve bodies for power plant boiler , a new process named “ shear extrusion ” is described in this paper . the numerical simulation analysis is carried out by using the 3 - d deform software to predict the distribution of velocity , stress , strain and temperature fields during the forming process and the flow law of metal . then the numerical simulation results are testified by simulative experiment . finally , large - size valve bodies have been successfully formed by the screw press
  文摘:针对电站锅炉用大型截止阀体的制造新工艺? “剪切挤压” ，利用数值模拟的方法对剪挤工艺进行研究，得到了成形过程中速度、应力、应变及温度场等的分布及金属流动规律，并通过物理模拟实验进行了验证，进而为获得阀体剪挤制造的最佳成形工艺参数提供可靠依据。

• distribution of velocities in Hindi